Enable interactive mode

Note: If you use role-based administration:

You must have the Policy setting - firewall right to configure a firewall policy.
You cannot edit a policy if it is applied outside your active sub-estate.

The firewall can work in interactive mode, asking the user how to deal with detected traffic. For more information, see Interactive mode.

To put the firewall in interactive mode on a group of computers:

Check which firewall policy is used by the group(s) of computers you want to configure.
See Check which policies a group uses.
In the Policies pane, double-click Firewall, and then double-click the policy you want to change.
On the Welcome page of the Firewall Policy wizard, click Advanced firewall policy.
Under Configurations, click Configure next to the location that you want to configure.
On the General tab, under Working mode, click Interactive.