Display filter

This page restricts the packet capturing to specific types of packets. There are further filtering conditions such as the type of interface, ether type, source IP address & destination IP address.

  1. Go to Diagnostics > Packet capture and click Display filter.
  2. Enter details to configure the display filter
    Interface name
    From the list, select the physical interface used for filtering packets logs.
    Ethernet type
    Select the Ethernet type: IPv4 or IPv6 or ARP.
    Ethernet type is a field in an Ethernet frame. It is used to indicate the protocol encapsulated in the Ethernet frame.
    Packet type
    From the list, select the packet type used for filtering packets.
    Source IP
    Specify source IP address (IPv4/IPv6).
    Source port
    Specify source port number.
    Destination IP
    Specify destination IP address (IPv4/IPv6).
    Destination port
    Specify destination port number.
    Reason
    Select the reason to display the filter from the available options.
    • Firewall
    • LOCAL_ACL
    • DOS_ATTACK
    • INVALID_TRAFFIC
    • INVALID_FRAGMENTED_TRAFFIC
    • ICMP_REDIRECT
    • SOURCE_ROUTED_PACKET
    • FRAGMENTED_TRAFFIC
    • APPLICATION_FILTER
    • USER_IDENTITY
    • IPS
    • MAC_FILTER
    • IPMAC_FILTER
    • IP_SPOOF
    • NEIGHBOR_POISONING
    • SSL_VPN_ACL_VIOLATION
    • VIRTUAL_HOST
    • ICMP ERROR MESSAGE
    Status
    Select the status of the filter from available options.
    • Allowed
    • Violation
    • Consumed
    • Generated
    • Incoming
    • Forwarded
    Rule ID
    Specify ID for the rule.
    User
    Select a user from the list of already existing users.
    Connection ID
    Specify a connection ID.
    Clear
    Click to remove the filter settings.
  3. Click Save.