Interface configuration

Use this screen to configure interface settings.

Interface menu screens

The following screen displays the current network settings like IPv4 Address/Netmask and/or IPv6 Address/Prefix for all the Ports. In addition, it displays IPv4 Address/Netmask and/or IPv6 Address/Prefix of Aliases, if configured.

            Network Settings
                Interface Name      : PortA (Physical)
                Zone Name           : LAN
                
                IPV4/Netmask        : 172.16.16.16/255.255.255.0 (Static)
                IPV4 Gateway        : N.A.
                
                Ipv6/Prefix         : Not Configured
                IPV6 Gateway        : N.A.
                
                Configured Aliases
                
                No Alias Configured
            
            Press Enter to continue ......
        
            Network Settings
                Interface Name      : PortB (Physical)
                Zone Name           : WAN
                
                IPV4/Netmask        : 10.10.10.1/255.255.192.0 (Static)
                IPV4 Gateway        : 10.10.10.254 (OK)
                
                Ipv6/Prefix         : Not Configured
                IPV6 Gateway        : N.A.
                
                Configured Aliases
                
                No Alias Configured
            
            Press Enter to continue ......
        
            Network Settings
                Interface Name      : PortC (Physical)
                Zone Name           : DMZ
                
                IPV4/Netmask        : 172.16.16.17/255.255.255.255 (Static)
                IPV4 Gateway        : N.A.
                
                Ipv6/Prefix         : Not Configured
                IPV6 Gateway        : N.A.
                
                Configured Aliases
                
                No Alias Configured
            
            Press Enter to continue ......
        
Note VLAN and WLAN interfaces are not displayed here.

Set Interface IP Address

This section allows setting or modifying the Interface Configuration for any port. Following screen allows setting or modifying the IPv4 Address for any port. Type y and press Enter to set IP Address.

Set IPv4 Address (y/n)  :   No  (Enter) >

Displays the IP Address, Netmask and Zone and prompts for the new IP Address and Netmask for each Port.

Press Enter if you do not want to change any details. For example, we are skipping changing the network schema for Port A and B while updating the IP Address and Netmask for Port C, as shown in the image below:

                Network configuration of Ethernet PortC
                
                    Current IP address  :   172.16.16.17
                    New IP address      :   10.10.1.5
                    Current Netmask     :   255.255.255.255
                    New Netmask         :   255.255.255.0
                    Zone                :   DMZ (DMZ)
                    
                Changing IP Address of the device ...... Done.
            
Note
  • The network configuration settings described above are applicable to Gateway mode deployment.
  • Aliases such as, VLAN, DHCP, PPPoE, WLAN and WWAN settings cannot be configured through the CLI.
  • The steps described above are for setting or modifying IPv4 addresses only. The screen elements differ slightly for IPv6 configuration.