| Update Local AP |
The page allows one to update Local AP. |
Sample Configuration | |
---|---|
Parameter | Mandatory | Default | Description |
---|---|---|---|
Id | Yes | Displays ID of the Access Point. Id confines to:
| |
Label | No | Specify label | |
Country | Yes | Select Country where the Access Point is located. Country confines to:
| |
Network | No | Select Wireless Networks for the Access Point. Network confines to:
| |
BridgeToEthernet | Yes | Enable to bridge the wireless networks to Ethernet BridgeToEthernet confines to:
Applicable only for the wireless networks that are of type, Bridge To LAN.. | |
DynChan | No | Disable | Select this to enable Access Point to scan for channels dynamically.(5 GHz) DynChan confines to:
|
TimeBasedScan | No | Disable | Select this to enable Time Based scan for Access Point.(2.4 GHz) TimeBasedScan confines to:
Applicable only if Dyn Chan is enabled.. |
Channel | Yes | Select a channel that will be used by the access point.(2.4 GHz) Channel confines to:
| |
ChannelWidth | No | 20MHz | Determines the speed and throughput of the frequency band in use. ChannelWidth confines to:
Applicable only in band.. |
Channel5GHz | No | Channel that access point must use for 5 GHz. Channel5GHz confines to:
| |
TimeBasedScan5GHz | No | Disable | Turns time-based scan on or off for the access point (5 Ghz). TimeBasedScan5GHz confines to:
Applicable only if Dyn Chan is enabled.. |
Time | No | Scan time for access point (5 GHz). Time confines to:
Applicable only if 'Time Based scan'(5 GHz) is enabled.. | |
TXPower5GHz | No | 100% | Transmission power output for 5 GHz band. TXPower5GHz confines to:
|
DynChan5GHz | No | Disable | Allow or stop access point's dynamic scan for 5 GHz band. DynChan5GHz confines to:
Dyn chan export status: Disabled: Channel is static, DCS is disabled 1: Channel set to auto, DCS is not set Enabled: Channel set to auto, DCS is set. |
ChannelWidth11a | No | 40MHz | Determines the speed and throughput of 5 GHz band. ChannelWidth11a confines to:
Applicable only in 5GHz band.. |
BridgeToPort | No | Select Port to create bridge with wireless network. BridgeToPort confines to:
The interface must have an IP address and should not belong to the WAN port or any other bridge.. | |
Zone | No | Select Zone for bridge connection Zone confines to:
| |
TXPower | Yes | 100% | Select the transmission power for the Access Point. TXPower confines to:
|
Band | Yes | Select Local AP band , either 2.4Ghz or 5Ghz Band confines to:
| |
Time | No | Select Scan Time for the Access Point(2.4 GHz). Time confines to:
Applicable only if 'Time Based scan'(2.4 GHz) is enabled.. |
Operation | Status | Message |
---|---|---|
Update Local AP | 200 | |
Update Local AP | 500 | |
Update Local AP | 523 | |
Update Local AP | 524 | |
Update Local AP | 542 | |
Update Local AP | 216 | |
Update Local AP | 541 | |
Update Local AP | 543 | |
Update Local AP | 545 | |
Update Local AP | 544 | |
Update Local AP | 547 | |
Update Local AP | 548 | |
Update Local AP | 561 | |
Update Local AP | 564 | |
Update Local AP | 565 |