Add RED Tunnel Wizard

This page describes how to set up a RED Site-to-Site Tunnel using wizard.

For such a connection, you need a RED server and a RED client. Ensure that RED is activated on client and server devices. Go to Device Configuration > Configure > System Services > RED and enable RED for client and server devices.

  1. Configure the RED Server.
    1. Go to Device Configuration > Configure > Network > RED Device Management, and click Add RED Wizard.
    2. Specify Branch Name.
    3. Select Type as "Firewall-RED-Server".
    4. Select Firewall Device.
    5. Select Tunnel ID. It is recommended that you set it to "Automatic". Ensure that both ends of the tunnel use the same tunnel ID.
    6. Specify Description.
    7. As RED IP, enter the LAN IP of the new RED server interface.
    8. Select RED Netmask.
    9. Select Zone.
    10. Enable Tunnel compression if required.
    11. Click Next to generate Provisioning File.
  2. Provisioning File generation.
    1. The generation of Provisioning File will start automatically after you Click Next in the RED Server section.
    2. The Provisioning File will be attached to the RED Client in the next step automatically after the generation process is over.
    3. Click Continue to configure RED Client.
  3. Configure the RED Client.
    1. Specify Branch Name.
    2. Select Type as "Firewall-RED-Client".
    3. Select Firewall Device.
    4. As Firewall IP/Hostname specify the IP address of the machine on which the Firwall RED Server was defined.
    5. Upload the Provisioning File downloaded after configuring Firewall-RED-Server.
    6. Specify Description.
    7. As RED IP, enter the LAN IP of the new RED client interface.
    8. Select RED Netmask.
    9. Select Zone.
    10. Click Finish.
    The RED Site-to-Site tunnel will be established and active.